Day 1.......?

Day 1

Luke Kirchner

Day 1........?

Alright, here we are! The first day of my A-Term, "Finishing the Falcon". In reality, though, we have been doing intensive work over spring break for the last 5 or so days. Let me tell you, in those 5 days we have done more than we have managed to do in the last 8 years. 

The moment the engine came to life!

For starters, we got the engine running! Now we knew the engine ran well after it was built and put on a dyno, but this was the first time it had ever run in the finished chassis of the car. The engine is a ford 289 block that has been turned into a 347 stroker and let me tell you.... it's loud. Within minutes the homeowners association was already protesting in our front driveway. But who cares? It sounds heavenly!

Today (Monday), we decided to turn down the loudness and crank the voltage. It was time to work on the wiring harness. This is essentially the series of wires that goes from the battery, all the way to the taillights, and everywhere in between. Because it was raining, we brought the three harnesses (Engine, Dash, and Trunk) inside to map and re-wrap. These wires were stripped from the car years ago so as you could imagine, it smelled like terrible ancient sweat. Truly gross. 

The old wiring harness

Once we labeled every connector on the harness, we started re-wrapping with better electrical tape and wire loom cover to ensure that it will last for years. This lasted for about 5 hours as we went through every single inch of that harness and re-wrapped it. Im excited to eventually install it!  



Comments

Post a Comment

Popular posts from this blog

Day 9: Fender Bender

Image
Day 9 Luke Kirchner Fender Bender Don't worry.... we actually didn't bang up a fender... but we did put them on! We woke up bright and early this morning, excited to work on starting and finishing all four doors. Almost immediately we noticed that our felt ordered from a catalog was not enough and that the glass would rub on the sides. After a couple of frantic phone calls to get those parts ordered, we decided to just put the doors on hold and work on the front of the car.   Looking like a hot rod! First, however, we had to start with the hood. The tough part about putting on the hood was not the weight, but the sheer size. Luckily, there were alignment holes that we could use so we knew the correct position for the hood. With the help of my mom, my dad and I bolted down the hood. We noticed that it looked slightly off-center, but we were going to wait to see how the gaps were when the fenders were put on. Now we can finally keep the engine bay clean from all the pollen! Splas
Read more

Day 5: With a Little Help From My Friends

Image
Day 5 Luke Kirchner With a Little Help From My Friends I woke up today to see the man, the myth, the legend....the destroyer..... Joel! My cousin Joel came over today to help work on finishing the gauge wiring and to try and start the engine once again. As usual, things got whacky real fast.  Our first task was to finish wiring the engine bay with our harness. Weaving through pillars and small holes, we managed to connect every little piece - from the horns to the headlights to the alternator. Everything was now attached to something! This meant we could focus our attention back on the gauge cluster to see what we needed to work on. Putting on the final screws, we could hardly hold our excitement to finally turn that key and start this car with everything wired up. I actually almost saw a smile slip from Joel's face. It was getting serious.  Once we made sure all the connectors were attached and all the screws were in, we decided to try and crank the engine to get fuel to the carbu
Read more